BREAKER ACCESSORIES

Transformer Components manufactures a complete line of accessories to facilitate the assembly of circuit breakers into oil-filled distribution transformers.

Signal Lights

Operating Handle

Overload Switch Assemblies

Operating Rod

Signal Light

When the transformer is thermally overloaded, the signal light will light, serving as visual evidence that an unusual overload has occurred on the transformer. In this way, the signal light serves as a continuous load-survey device on each individual transformer. This light will remain on until reset by the circuit-breaker operating handle. Our signal light uses a standard 6V/250mA, GE bulb No. 44, and is replaceable from outside the transformer by removing the signal light lens.

 

7591ZE9399 – Signal Light Assembly

Product NumberDescription
5999ZB0199Lens (Red)
5111ZA0399Lens Gasket
5999ZR8399Light Bulb
5111ZA5399Tank Gasket
5999ZB2499Hex Jam Nut (3/4″-16)
5999ZB0299Terminal Clip

Operating Handle

When the breaker trips (or the signal light circuit is closed), the breaker can be reset to normal by using the operating detail handle. The breaker (and signal light) is reset by moving the operating detail handle to “RESET” position and then to the “CLOSE” position.

If the transformer has returned to a normal operating temperature, and if any excessive load (or secondary fault) has been removed, this reset/close operation will return the breaker to its normal operation position by closing the main contacts and opening the signal light contacts.

Overload Switch Assemblies

ECI manufactures an overload switch for use in oil filled distribution transformers. This switch turns on a light signaling the transformer is overloaded however, unlike a circuit breaker, it will not disconnect the transformer. The overload switch is the ideal product to assist electric utilities in locating overloaded transformers without disrupting service to their customers. The switch can be reset while the transformer continues to operate.

Operating Rod

The operating rod is used to complete the connection between the operating handle and circuit breaker. It is made of a 0.219” diameter steel rod with a ¼”-20 rolled thread.

Product Number Length of Rod (inches) Length of Thread (inches)
7572ZH5399 4 3
7572ZH6099 4.74 3
7572ZH4299 5.5 3
7572ZH4399 6.5 3
7572ZH4799 7.5 3
7572ZH5199 8.5 3
7572ZH4499 9 3
7572ZH5799 9.5 3
7572ZH4699 10.5 3
7572ZH4899 12 3
7572ZH1299 12 6
7572ZH6199 12.25 3
7572ZH4999 13 3
7572ZH5099 13.5 3
7572ZH5299 15 3
7572ZH5499 16.5 3
7572ZH5699 18 3
7572ZH5899 19.5 3
7572ZH8399 19.5 13
7572ZH5599 21.5 3
7572ZH5999 23.5 3

Accessibility Toolbar